Posts tagged lathe
Over Christmas break, Lisa’s dad let me use his lathe again, and I made a few more tops. I made 4 in all, but two of them we gave to friends before we snapped a picture. In any case, here are two of the new ones with the old ones. One of them, the one on the right in the first picture, I also gave to a friend, Bob.
The handles aren’t quite as polished as I would like and the tips that they spin on aren’t as smooth as I would like to give the whole top a nice smooth look, but overall they turned out alright and do a decent enough job of spinning. I was maybe a little aggressive trying to by fancy by carving out towards the inside of the volume, which made it a bit difficult to sand them properly, so that is why in the second photo the third top has a bit of a rough edge. I started to lose a little patience with the sanding. But, still, they look good, were relatively easy to make, and were fun to make too.
My wife’s dad has a nice woodworking shop, which he uses to make great bowls and boxes. He let me play with the lathe a little bit. I thought tops would be a relatively easy thing to make so I took a stab. I had a basic idea in mind when I started, but as I turned the wood, something else developed. The one on the left was my first attempt. It was sort of what I had in mind as a more traditional top, but then I put different grooves and such as I went along. I wasn’t really thinking well, though, and separated it from the lathe before sanding it. It turns out it is a lot easier to sand something like this if you keep it on the lathe and let it spin as you sand it. Same with finishing. My father-in-law had a finish that you apply as the lathe is spinning. It heats up a wax that is part of the finish that makes the finish deeper and more even. With those things in mind, I made the second top, which is somewhat simpler in overall design, except for the depression at the top. It is also wider, with more mass distributed further from the top axis, which I think is why it likely spins a lot longer than the first one.
I made these for my daughter, who I think is a little bit too young to really care. Her cousin, though, who is 3 and a half, really enjoyed watching them, even if she couldn’t get them to spin. It makes me want to get a lathe. It seems there are lots of cool things you can do with just that one tool.
At left are are a couple of finger puppets I got from my godmother when I was a kid. I don’t remember playing with them, but I remember them being around when I was older. Some of them, especially the alligator, are a little worse for wear, but overall they’ve held up very well, considering they are maybe 35 years old or so and have not been treated in the most kind manner (after all, I was a kid!). I just find them great. The expressions are awesome (a buck-tooth lion?!?) and while the coloring is simple — all solid for each one — the shapes are very nicely designed.
I don’t know much about these. All they say on the bottom are “Made in Japan,” something you don’t see on toys very often any more. I don’t know if Japan used to be a bit like China is now, the maker of all things like this. I’m really curious to know more about them. Were they part of some bigger set? Were they some sort of promotional item? Anyone know?
They just seem so great in their simplicity, the kind of thing that we just don’t see much of any more. Sure, they are plastic, but they don’t make any noises, they don’t take any batteries (my daughter was trying to squeeze them, either trying to get them to squirt like her bath toys or make noises like some of her stuff animals). I just really like what they represent to me of a somewhat simpler time when toys left something to the imagination. I hope that my daughter enjoys them when she is a little bit older (those are her feet in the background, next to my wife’s).